byline

A Source for Workplace Safety News and Notes - from ComplianceSigns.com ®

July 19, 2017

Lockout / Tagout Inspections - What You Need To Know

Lockout power before removing guards
If your operation has lockout / tagout (LOTO) procedures in place, or if any LOTO is ever used, OSHA requires inspections of your procedure at least once every 12 months. But the OSHA compliance directive for control of hazardous energy is a whopping 136 pages of OSHA-speak.

Fortunately, the safety training pros at weeklysafety have penned an article that explains what kinds of inspections are necessary and outlines best practices for LOTO inspections. Here are some key points form the article.
  • LOTO inspection is are intended to ensure that the LOTO procedures in place are adequate. If they are not, corrections must be made.
  • The inspector cannot be the same person using the LOTO procedure during the inspection, so there must be at least two competent, authorized persons present during any LOTO inspection - one inspector and one worker following the LOTO procedure.
DANGER do not open
LOTO inspections should determine if:
  • Steps of the current LOTO procedure are being followed
  • Employees involved know their responsibilities as they pertain to the procedure
  • Current procedure is adequate to provide necessary protection, or what changes are needed if the procedure is not adequate
Don't limit LOTO training to specific machine operators or maintenance workers. All employees must know what LOTO means and what they should do if they encounter LOTO devices or signs while on the job.

Resources:

No comments:

Post a Comment